Scan FOV Options

• Three flexible FOV sizes: 18×14cm, 16×12cm, 18×10cm
• Ultra‑wide FOV supports non‑fusion one‑scan imaging
• Visualizes full dentition, TMJ and maxillary sinuses for sinus lift and zygomatic implant surgery
• Continuous output up to 200 sets of high‑quality images

Image Resolution

• Minimum voxel size: 0.05mm, delivers ultra‑sharp diagnostic details
• Supports maxillofacial and partial CT scanning for diverse clinical cases

Integrated Imaging Modes

• CT mode: Full & partial cone beam CT scanning
• OPG: Standard OPG & segmented OPG; segmented scan reduces repeated radiation exposure
• Ceph: Two optional detectors
  1. Linear array detector: High‑resolution cranial and metacarpal bone images
  2. One‑shot flat‑panel detector: 0.8s low‑dose fast imaging
• Optional intraoral X‑ray device with two installation solutions
• Single‑room installation to save clinic space and cut costs

Low‑dose & Advanced Reconstruction Algorithms

• LDira Automatic Low‑dose Algorithm Adult: 90kV‑4mA; Pediatric:70kV‑2mA, balances low radiation and high‑definition output
• Macra Motion Artifact Clear Reconstruction Algorithm: Eliminates patient‑movement image artifacts
• 3D Truth Recovery Metal Artifact Correction Algorithm: Reduces metal‑caused noise to avoid extra patient exposure
• Total Variation Wavelet‑Based Noise Reduction Algorithm: Efficient frequency‑domain & time‑domain denoising
• Hardening Artifact Correction Algorithm: Clear visualization of bone and soft‑tissue structures
• Dynamic Focusing Tomosynthesis Algorithm: Auto‑adjust grayscale and sharpness along dental arch
• Clear‑Vision Algorithm: Minimizes ghost image and distortion from spine or airway interference

Intelligent Diagnostic Software Features

• Automatic mandibular nerve marking
• TMJ diagnosis & airway segmentation
• Regional bone mineral densitometry
• Pre‑operative and post‑operative data comparison
• Fully automated cephalometric tracing & report generation
• Dental implant simulation (Panoramic & MPR interface)
• Automatic dental arch curve labeling, quick CT & panoramic report generation

Patient Positioning & Hardware Design

• Integrated sliding chair: Supports sitting & standing scan modes; improves experience for elderly and disabled patients; sitting scan lowers motion‑artifact risks
• Anti‑motion monitor: Alerts operators for movement that degrades image quality
• Electric jaw rest: 0.1‑mm minimal moving range for precise positioning
• Independently adjustable Ceph measurement height
• Adaptive head clip: Auto‑tighten & loosen during scanning
• Positioning laser lights for optimal patient alignment
• Height‑adaptive measurement, auto‑adjust device height via software

After‑sales & Service

• 365‑day online technical support
• 30‑minute response, 1‑hour solution provision
• 1‑on‑1 customized service for global dental clinic procurement